Series | Page 46 of 47 | Small Boats

Series

The garboards are built up of three planks joined with flush dory bevels and rivets. The seams between them are visible here with one running out at the transom and the other at the garboard's upper edge. To the far left is one of the butt blocks on the broad strake.

Small Boats Annual 2016February 2015

The Mower Dory

Sailing again after a century in hiding

One day in the early 1990s, a local contractor visited my boatbuilding shop in Marblehead, Massachusetts, telling me he’d been hired to convert an old boatshop into a playhouse. “The museums and antique dealers have been through it,” he said, “Take anything you want or it’s going to the dump.” The building was mostly empty but in the long back room there was a planking bench with odd parts scattered around. Above the bench, tucked under the eave, the blackened end of a tight roll of paper caught my eye. I took the roll down, dusted it off, and put it in the truck. That evening, I unrolled my find.
A bend in the river surrounded by farmland and forests provided me a place to camp. With little current and minor tides in the Mutlnomah Channel I could leave MAC overnight only slightly aground. A line from her bow to my wrist as I slept was all I needed to assure me that she'd not leave without me.

December 2014

Rowing the Columbia

Seeking serenity on a busy river

At Cathedral Park in Portland, Oregon, the Willamette River was flowing gently, leaving barely discernible eddies around submerged pilings a few yards from the beach. Skamakowa was 75 miles downstream and I had five days to get there relying on the current and a pair of oars. As I swung into the Willamette's current under the long shadow of St. Johns Bridge, I pulled hard to get away from diesel and car exhaust, ski boats, and boom boxes, and headed to the other side of the river.
The inner tube has more than enough length to get water out of a boat with 6' beam. The hose is set up without twists to assure the unimpeded flow of the water.

December 2014

A Hose for a Bilge Pump

Repurposing a bicycle-tire inner tube

The manual bilge pump that I use for my kayak isn’t very useful aboard my other boats. Without a hose it can’t get the water from the centerline some 3’ to the gunwale and overboard. My other pump, the one with a hose attached, went missing one day and I came up with a way to add a nice long hose to my kayak pump. I had an old bicycle inner tube that was just the right diameter to stretch over the spout of the pump. As a hose, it worked like a charm.